If you have some problems with the HVAC system, check out your home before calling a contractor. Find out which rooms are hot and which are cold. The contractor can probably figure out and fix the problem easier.
When HVAC is something you want to learn a little bit about, there’s nothing better than learning some tips first. You’ll find some great information in the following article that will give you the basics. Take some time and you’ll do great if you read along.
If the condenser for your HVAC system is located outside, make sure you clear away any debris that might settle in or around it. Things tend to pile up around these units, especially after storms come through, which could cause problems to your system. It could get too hot, leading to even more problems.
Always make sure you are up-to-date about your HVAC unit. Write down the make, model, and any maintenance history. The contractor will likely need all of this information.
Clean the fan blades and coils in your condenser each spring. For safety, always turn the power off first. Pull out each of the blades and clean them one by one.
By the end of spring, the fan blades and coils of your condenser should be thoroughly cleaned, so operation can proceed with greater efficiency. If you are doing more than a light surface cleaning, make sure that the power is shut off to the HVAC unit. Additionally, it’s important to clear out leaves and other debris from the outside condenser unit.
When you cut the grass, make sure your mower isn’t tossing clippings toward your outdoor units. Try shooting the clippings away from it. This includes grass clippings and leaves.
Cover your unit when you are mowing the lawn. Make certain the debris goes away from it. This applies when you are taking care of the leaves in the yard.
If your fan condenser has oil ports, you must lubricate it once per year. You will see rubber or metal caps covering the ports. Get an oil that is SAE 20 and put about 10 drops into each port, but don’t overfill it.
Lubricate the oil ports on your condenser once each year. You’ll find these ports are covered with a metal or rubber cap. Get an oil that is SAE 20 and put about 10 drops into each port, but don’t overfill it.
A shady spot is always a good choice for the placement of your outdoor compressor. In this way, it will be cooling air that is already somewhat cooled. This saves energy.
If you need to decide the best place to put your outdoor compressor unit, consider putting it in a location that is in the shade. If your unit is sucking in cooler air, it will have less work to do to cool that air as it sends it inside which boosts efficiency.
If possible, put your HVAC in a shaded area if it is outside. This will help you save on your energy bill.
When it gets cold outside, the outdoor condenser unit should be turned off. This means that you should turn it off to prevent damage if the weather falls under 60 degrees Farenheit. This helps the system last much longer and will have to be repaired less often.
Have your HVAC serviced at least yearly. Generally, you want it done in the fall and the spring. This will help you to avoid problems.
It’s not too tough to get into HVAC once you have information like what you read in this article. You just have to apply yourself to learning a bit about the subject. Best wishes as you begin your journey.
Having a programmable thermostat installed is a money saving idea. Turning down the thermostat around 10 percent for 8 hours per day can give you a 10 percent savings using the programmable thermostat. Also, you can find a thermostat that is controllable from a computer or smart phone.
Micro Clean Air Duct Cleaning https://www.microcleandfw.com/